• Home
    • Tips
    • Stop the Smell: How to Clean a Front-Loading Washing Machine

    Stop the Smell: How to Clean a Front-Loading Washing Machine

    Based on personal experience, these washers get dirty! Unfortunately for me, no one ever told me when I got my first house that I was required to actually clean this, and the resulting mildew that overtook my washer was horrifying. Don’t make the same mistake! Rather than running out and getting a strongly smelling detergent to mask the smell, follow the tips below and give your washer a thorough cleaning.

    Have you noticed your clothes smelling… musty? Even if you’ve switched the load from the washer to the dryer immediately after the cycle has ended? These tips will take care of the problem.

    If you’ve never taken the time to wash your washer, this task might take you a while (that is, if your machine doesn’t have a self-cleaning option) but will be worth every minute. After the initial scrub down happens, you can lighten the intensity of the task and simply give it a touch-up once a month.

    And if you want to permanently avoid that musty smell, leave the washer door open. Leaving the door open will allow leftover moisture to evaporate, minimizing the chance for mildew to grow on the rubber seal. This is especially important in the summer and in extremely humid climates. If you’re concerned about your fur or non-fur babies crawling in, invest in a front load washer lock. It can keep a door open just as well as it can keep it shut.

    What You Need


    • 1/4 cup Baking soda
    • 1/4 cup water
    • 2 cups Vinegar
    • All-purpose spray
    • Tea tree oil (optional)


    • Measuring cups
    • Scrubbing sponge
    • Paper towels or clean rag

    1. First, start by wiping down all exterior surfaces with your all-purpose spray including the top, sides, front, and front window. Then, open all doors/drawers etc. and wipe down all the surfaces you can get to, paying close attention to corners and cracks that dust could easily collect in.

    1. Next, combine 1/4 cup water and 1/4 cup baking soda and pour this solution into your detergent tray.

    1. Set the wash cycle for a large load, and place it on the hottest setting. Press the “start” button and let the baking soda do it’s thing!

    4. After the cycle has completed, find the release button and pop the detergent tray out of the drawer. Run it under hot water, or drop it in a soak bath to remove soap scum and buildup

    1. While the detergent tray is soaking, spray the rubber seal with vinegar and let it sit for a minute or two. Grab your rag (I prefer paper towels for this step because it can be quite messy, especially if you have mildew) and start wiping down the folds of the seal. Really get in there, and lift out any debris or hair that has become trapped.If you have a mildew problem, clean with vinegar and a few drops of tea tree oil. If you’re brave, use bleach. Keep going until your rag wipes clean.

    1. The baking soda detergent should have made the inside of your machine nice and shiny and odorless, but just to be safe I like to pour a few cups of vinegar inside while spinning the drum, and then I go back and scrub it down with a sponge.

    1. If you don’t feel like getting inside the machine and scrubbing your little heart out, just pour a cup of vinegar in the detergent tray (after you’ve removed the tray from the soak bath and put it back in place, of course) and run one more cycle on low. You can certainly apply both steps, but really only one is necessary.

    Source: Stop the Smell: How to Clean a Front-Loading Washing Machine | Apartment Therapy

    Trackback from your site.

    Kyle Barber

    Kyle is passionate writer, independant thinker, and digital savvy lady with a deep love of marketing and all the challenges it presents.

    Leave a Reply